How To Clean Resin From Your Screen And Don't Destroy It.

Resin 3D prints fail – The Reasons

An animated explanation to “Why did this happen?” When you move up to larger resin 3d prints, you also start seeing failures. There’s no blanket answer for all print failures. But in this video, he explores a few reasons why resin 3d prints sometimes fail. And hopefully, show you how you can get better results.

Check the video with all the reasons here -> Why 3D prints Fail.

Screen Full of Resin – Personal Experience

I have an Elegoo Saturn. I love my printer but some time, it does weird stuff.

In that case, the Pendrive failed and the top pressed the failed print into the FEP perforating it. At the beginning, I wanted to cry, but I got my spatula and scrapped the shit out of the screen. I was able to remove most of it.

But I couldn’t scrap all. Do you see the top corner? I was not able to remove that little bastard. I poured alcohol and rubbed and rubbed and i was only removing the glue from the sealant. So I checked internet.

The Solution

I promise that I will make a video with how I scrapped everything because I recorded it. But I wanted to let you know the solution right now before I forget to post.

The solution is a 10 dollar plastic shitty tool from Amazon. It is used for vinyl in cars and it is plainly a godsend tool. It does not damage the screen but it is enough sharp that it gets under the resin. It is plainly amazing. Best 10$ invested of my life.

Scrapper on Amazon

I looked everywhere in internet and I couldn’t find a solution but i found in one of Uncle Jesse Videos that he had some problem so i tried his advice and ….. he nailed it!